Intergrain UltraClear™ Interior
Durable, non-yellowing clear finish for natural-looking interior timber
Intergrain UltraClear™ Interior is a high-performance, water-based clear coating designed to protect and enhance interior timber while preserving its natural appearance. Ideal for modern interiors, it provides a durable, low VOC and low-odour^ finish that helps maintain the true look of light timbers without yellowing over time. It brushes on white and dries clear to ensure even coverage so no spots are missed.
Suitable for a wide range of interior applications including walls, ceilings, doors and windows, UltraClear™ Interior is especially effective for design-led spaces where maintaining a clean, natural timber finish is critical.
^Compared to solvent based products
*Drying conditions of 25°C and 50% relative humidity. Cooler or more humid conditions will increase drying times
|
Coverage: 10m2/L
|
Recoat: 2hrs
|
Full cure: 7 days
|
|
Clean up: Water
|
Sheen: Matt, Satin
|
Sizes: 4L
|
|
Areas
Interior walls, ceilings, hand railings, doors, windows, joinery, architectural features
|
|
Substrates
All interior timber
|
|
Locations
Interior
|
Stir thoroughly before and during use with a flat blade stirrer. Do not shake or thin.
- Apply three coats of UltraClear™ Interior with a quality synthetic or pure bristle brush, or roller, or spray (air-assisted or airless).
- Take care to apply sufficient product to edges and end grain. Maintain a wet edge to avoid lap marks and an uneven finish. When applying by brush, apply in the direction of the timber grain where possible. To aid application, soak the brush or roller in water and remove surplus before loading with UltraClear™ Interior.
- Do not overwork the product as this can result in a poor appearance. When spraying ensure adequate film build is applied to achieve maximum durability. It is normal for UltraClear™ Interior to have a milky appearance when first applied which disappears on drying.
- Allow a minimum of two (2) hours drying between coats. If required, sand lightly with a fine grit sandpaper to remove any raised grain.
- If coating large surfaces in warm conditions, wash the brush, roller, or spray machine out at regular intervals to allow smooth application.
- Do not apply in temperatures above 35°C or below 10°C.
- Do not apply to hot surfaces as doing so may result in difficult application and poor adhesion.
