Intergrain UltraPrep Sealer & Primer
Intergrain UltraPrep™ Sealer & Primer is a high performance sealer and primer formulated to be compatible with all Intergrain waterbased top coats. Intergrain UltraPrep Sealer & Primer seals bare and coated timber surfaces, locking in any previous water or oil based timber coating and allowing the application of any Intergrain water based coating over the top. Intergrain UltraPrep Sealer & Primer will also extend the life of any Intergrain water based top coat when applied underneath.
|
Coverage: 5 m²/L
|
Recoat: 4hrs
|
Full cure: 7 days
|
|
Clean up: Water
|
Sheen: N/A
|
Sizes: 1L, 4L, 10L
|
|
Areas
Decking, Fences
|
|
Substrates
Cypress Pine, Jarrah, Merbau, Spotted Gum, Treated Pine
|
|
Locations
Exterior
|
Methods: brush, roller, spray, Applicator
- Remove excess water from the surface and allow the timber to dry for at least 1 hour before coating. If coating over an existing coating, surface must be allowed to completely dry. Stir Intergrain UltraPrep Sealer & Primer thoroughly before and during use with a flat blade stirrer. Do not thin.
- Apply Intergrain UltraPrep Sealer & Primer using the Intergrain DeckBrush™ (recommended), flat deck applicator, paint brush, roller or spray (air assisted airless or airless).
- Apply at the correct application rate (see COVERAGE). Do not overspread or apply thinly as insufficient film thickness will result in lap marks and compromise performance and durability. When coating large areas, work in sections, apply long strokes and use natural breaks in the boards as stopping points. If spraying or applying by roller, it is recommended to back brush to even out the finish and avoid spotting.
- Allow to dry for at least 4 hours before applying any Intergrain water based top coat.
Important: All timber is required to be free from dust, mould and site contaminants prior to coating. Follow all relevant product label instructions when using Intergrain products. Do not apply to hot surfaces or those in direct sunlight, as doing so will result in difficult application, poor adhesion and blistering.
Do not apply in temperatures above 35°C or below 10°C or if rain or dew is expected within four hours of application. Lightly dampening timber before painting will ease application in temperatures above 28°C.
Maintenance
Apply Intergrain UltraPrep Sealer & Primer every 3 months until a top coat is applied over the top.
