Intergrain Enviropro Timberseal Water Based

Designed for professional applicators, Timberseal Water Based is a high performance water based sealer for oily and tannin rich timbers, that helps to reduce the risk of tannin bleed. It is designed to minimise grain raise, so does not need to be sanded. Timberseal is low odour and meets the VOC requirements of the Green Building Council Australia (GBCA).

Coverage m2/L: 10
Recoat time (hours): 1
Fully cured: N/A
Clean up: Water
 Sheen: None Sizes available: 5L

All surfaces must be clean, dry, free of wax, grease, dust and other contaminants. The presence of contaminants increases the possibility of rejection and delamination. Fine sand the floor, finishing with 100 grit sandpaper, then with 150 mesh screenback and vacuum thoroughly with a commercial grade vacuum cleaner.

Methods: 10mm nap microfibre roller

1. Shake the pack for 1 minute prior to application.
2. Cut in edges with a brush. Apply Timberseal Water Based at 10 to 12m²/L using a 11mm Selleys Spirit micro-fibre roller.
3. Do NOT overwork the coating. Finishing strokes should be in the direction of the timber grain.
4. The sealer does not need to be sanded.

Areas: Parquetry, Timber floors, Stairs

Substrates: All interior timber

Locations: None