Intergrain Enviropro Timberseal Ultra

Designed for professional applicators, Timberseal Ultra is a high performance water based sealer, designed to maintain the natural colour of timber. It is formulated for easy sanding, powdering up when screened. Timberseal Ultra is low odour and meets the VOC requirements of the Green Building Council Australia (GBCA).

Coverage m2/L: 10
Recoat time (hours): 1
Fully cured: N/A
 Clean up: Water
 Sheen: None  Sizes available: 5L

All surfaces must be clean, dry, free of wax, grease, dust and other contaminants. The presence of contaminants increases the possibility of rejection and delamination. Fine sand the floor, finishing with 120 grit sandpaper, then with 150 mesh screenback. Vacuum thoroughly with a commercial grade vacuum cleaner.

Methods: 10mm nap microfibre roller

1. Shake the pack for 1 minute prior to application.
2. Cut in edges with a brush. Apply Timber Seal Ultra at 10 to 12m²/L using a 11mm Selleys Spirit micro-fibre roller.
3. Do NOT overwork the coating. Finishing strokes should be in the direction of the timber grain.
4. If needed, sand the sealer with a worn 180 or 220 screenback. The sealer does not need to be sanded, however sanding the sealer coat will improve the appearance of the final finish

Areas: Parquetry, Cork, Timber floors, Stairs

Substrates: All interior timber

Locations: None