Intergrain Nature's Timber Oil
Intergrain Nature’s Timber Oil is a natural, oil based timber finish made from 95% sustainable ingredients. The penetrating formula replicates timber’s natural defences against aging, saturating the cells to protect against drying out. Added ingredients give resistance to water, UV and mould. The natural ingredients in Nature’s Timber Oil give a rich, natural oiled finish.
|
Coverage: 6m2/L
|
Recoat: 4hrs
|
Full cure: 7 days
|
|
Clean up: Warm soapy water
|
Sheen: None
|
Sizes: 1L, 4L, 10L
|
-
Natural
-
Jarrah
-
Merbau
Select a colour above to get an idea of how different Intergrain coatings will look
*all colours displayed on this page show 2 coats on merbau timber
|
Areas
Decking, Fences, Exterior timber, Timber Furniture
|
|
Substrates
Cypress Pine, Jarrah, Merbau, Spotted Gum, Treated Pine
|
|
Locations
Exterior
|
Methods: Intergrain DeckBrush (recommended), spray, lambswool applicator, quality brush
1. Stir thoroughly before and during use with a flat blade stirrer.
2. If project requires more than one can of Nature’s Timber Oil, mix all cans together in one large container to achieve colour uniformity.
3. Apply Nature’s Timber Oil using a brush, lambswool applicator, or spray.
4. When coating large areas, such as decking and weatherboards, coat no more than three boards at a time. Complete an entire length or continue until a natural break such as a window occurs.
5. Wait four hours to dry and apply a second coat. If necessary, sand lightly between coats to remove any raised grain.
6. Wait 30 minutes after the second coat is applied and wipe off excess surface oil. Ensure that excess is wiped before the coating gets tacky.
7. Do not apply to hot surfaces or those in direct sunlight, as doing so may result in difficult application, poor adhesion and blistering.
8. Do not apply in temperatures above 35°C or below 10°C or if rain or dew is expected within four hours of application.
