Intergrain Hot Weather Additive

Intergrain Hot Weather Additive is a high performance wet edge extender for use with Intergrain water based coatings. Hot Weather Additive increases the working time of water based timber coatings. It improves levelling, especially at higher temperatures and helps to reduce the occurrence of lap marking caused by the coating drying too quickly.

Full cure: N/A
Clean up: N/A
Sheen: N/A
Sizes: 250ml
   
Areas
Exterior timber
Substrates
All exterior timber
Locations
Exterior
Add up to 5% of Hot Weather Additive into the selected compatible water based coating (Note: see datasheet for full listing of compatible water based coatings). For example, if using 1 litre of Intergrain Ultradeck, 50mL of Hot Weather Additive as a maximum would be required.
Mix the final solution for 2 minutes to incorporate Hot Weather Additive into the selected product.
Note: Hot Weather Additive increases the drying time of the coating. Therefore, a longer time before over coating will be required under certain conditions.

1. To avoid spillage, remove 5% of the timber coating from the can before adding Hot Weather Additive.
2. Add up to 5% of Hot Weather Additive into the selected compatible water based coating.
3. For example: If using 1L of Intergrain Ultradeck, 50mL of Hot Weather Additive as a maximum could be added. Mix the final solution for two minutes with a broad flat stirrer to incorporate Hot Weather Additive into the selected product, trying to avoid the introduction of air bubbles.
4. Add removed timber coating back to the can as space becomes available. Stir thoroughly.
Note: Hot Weather Additive increases the drying time of the coating. Therefore, a longer time before over coating will be required under certain conditions.