Exterior
Product Range
Product Range
Can I use UltraClear over NaturalStain?
For Exterior Timber
UltraClear™ Exterior
A tough, clear, water based timber finish providing superior protection against the
weather including UV radiation. Available in gloss and satin, UltraClear Exterior will not yellow like oil based coatings.
Where To UseOn exterior timber including doors, window frames and trims. UltraClear Exterior can also be used on the inside of exterior doors and window frames.
Note: UltraClear Exterior is not suitable for heavy wear surfaces (such as decks and walkways). For these areas use UltraDeck, NaturalStain or DWD. Gloss Level
Satin or Gloss.
Preparation
Preparation is the key to long lasting, professional looking results. Click here for how to prepare the timber surface before coating.
Note: For oily, tannin rich and marked timbers only, clean all timber with Reviva closely following label instructions. Ensure surface is rinsed clean and allowed to thoroughly dry
Preparation is the key to long lasting, professional looking results. Click here for how to prepare the timber surface before coating.
Note: For oily, tannin rich and marked timbers only, clean all timber with Reviva closely following label instructions. Ensure surface is rinsed clean and allowed to thoroughly dry
Apply With
Brush, spray or applicator.
Brush, spray or applicator.
No. of Coats Required
Three coats. Four coats will be required in extreme conditions such as full sun exposure, around pools and in humid areas, and may be required on porous timbers.
Three coats. Four coats will be required in extreme conditions such as full sun exposure, around pools and in humid areas, and may be required on porous timbers.
Recoat Time
Allow minimum 4 hours drying at 25°C and a maximum 7 days between coats.
Allow minimum 4 hours drying at 25°C and a maximum 7 days between coats.
Drying/curing Time
Touch Dry: 1 hour at 25°C and 50% humidity. Full curing 7 days.
Touch Dry: 1 hour at 25°C and 50% humidity. Full curing 7 days.
Coverage Rate m2/L
10-12 square metres per litre depending on the porosity of the timber.
10-12 square metres per litre depending on the porosity of the timber.
Sand Between Coats
If necessary, sand lightly between coats to remove any raised grain.
If necessary, sand lightly between coats to remove any raised grain.
Clean Up With
Water.
Water.
Packaging Sizes
1 and 4L.
Please refer to the instructions provided on the Intergrain Timber Finish container before commencing your project.
1 and 4L.
Please refer to the instructions provided on the Intergrain Timber Finish container before commencing your project.
*Coverage rates are subject to variation between different timber species. To ensure adequate timber protection, this coverage should not be exceeded.
